Before you start

Before you begin, make sure:

The inverter is physically installed and powered on following the FoxESS manual
The inverter is updated to the latest software version
The FoxCloud2.0 app is installed on your device

Step-by-Step Instructions

1. Connect the inverter to the network

Connect an Ethernet cable to the LAN port on the inverter
Verify the connection is established by checking the network status in the FoxCloud2.0 app

For network infrastructure requirements and troubleshooting, see Infrastructure requirements for the gateway.

2. Access the inverter settings

Open the FoxCloud2.0 app
Follow the instructions to complete the inverter setup in the App

3. Plug&Play discovery and configuration

This inverter supports Plug&Play, requiring no manual configuration. It is automatically detected during gateway commissioning and configured with the appropriate settings.

4. Discover the inverter in the commissioning wizard

The inverter is now ready for the commissioning wizard. The gateway will scan the network to find available devices, which may take a few minutes. Once complete, the FoxESS H1 G2 / AC1 G2 inverter will appear on the results page.

When the inverter is detected, in most cases set the asset type to Hybrid (PV and Battery) from the dropdown.

If you are using the inverter exclusively as a PV inverter, select PV System. If it is used solely as a battery inverter, choose Battery.

FAQ

Why isn't the inverter appearing in the commissioning wizard?

Check that you completed the inverter setup with no errors in the FoxCloud2.0 app. Verify all components (data logger, inverter, battery, energy meter) work correctly. Make sure the Ethernet cable is connected to the LAN port. Restart the gateway and wait for the network scan to complete.